INSTAlliNG THE BATTERY
Follow these steps to install the supplied battery into the handset. Then, charge the battery as described under "Charging the Battery."
1.Use a small Phillips screwdriver to remove the screw that secures
the battery compartment cover. Then, remove the cover by
sliding it in the direction of the arrow.
2.Attach the battery'sconnector to the connector inside the battery compartment. Then, place the battery inside the compartment.
3.Replace the battery compartment cover and secure it with the screw.
The supplied battery should last for approximately two years. When the battery cannot fully recharge, you will need to purchase a new one from your local Uniden store.
CHARGING THE BATTERY
YOU MUST CHARGE A NEW BAT- TERY FOR AT LEAST 24 HOURS BEFORE YOU FIRST USE THE PHONE.
When you first charge the battery, set POWERON/OFF to OFF. When you recharge the battery, you can leave the power on. Recharge the battery whenthe BAIT LOW indicator lights.
~
.
~
t
To charge or recharge the battery, place the handset on the cradle. The CHARGEindicator will then light.
After you charge the battery, pick up the handset, set POWERON/OFFto
ON, and place the handset back on the base. This sets the security ac- cess protection code, which prevents others with cordless phones from using your telephone line.
Notes:
. If the CHARGEindicator does not
stay lit when you place the handset on the cradle, be sure the battery and AC adapter are properly con- nected.
5