Phonebook
Phonebook allows you to dial a number using just a few key presses.
Your phone stores names/numbers in the phonebook memory location, and you can search names in alphabetical order. You have a total of 100 locations that can be used for the phonebook (including the Speed dial locations) and Caller ID messages.
If you get an incoming call, a transferring call, or page, the operation is canceled.
Storing Phone Numbers, Names, Distinctive Rings, and Speed Dial
1)When the phone is in the standby mode, press pb/rocket/<. The handset displays the number of the phonebook locations used, and information on searching and storing
phonebook locations.
(1st line) the number of the phonebook locations (2nd line) How to search (the number keypad, + or
(3rd line) How to enter the storing operation (Press select/ch)
2) Press select/ch, then “Store/Edit Name” appears.
3)Store the name (up to 16 characters) by using the number keypad.
•See the “Steps for entering names and special characters” (see page 28).
•Use cid/> and pb/rocket/< to move the cursor to the desired location.
•Use xfer/del to delete characters as needed.
•Press and hold xfer/del to delete all the characters.
If a name is not required, go to step 4.
4) Press select/ch to store the name, then “Store/Edit No.” appears.
5)Press the number keypad to enter the phone number (up to 20 digits), then press select/ch to store the number.
•If you press end or don’t press a key within 30 seconds while in the storing operation, the phone will return to the standby mode.
•When the memory is full, you will hear a beep and “Memory Full” appears. You cannot store names and numbers.
•The pause key counts as one digit. Pressing redial/p more than once increases the length of pause between numbers.
P H O N E B O O K