Uniden UND1685 manual FCC Part 15 Information

Page 22

The REN is used to determine the number of devices that may be con- nected to a phone line. Excessive RENs on a phone line may result in devices not ringing in response to an incoming call. In most but not all areas, the sum of RENs should not exceed five (5.0). To be certain of the number of devices that may be connected to a line, as determined by the total RENs, contact the telephone provider. The REN for this product is part of the product identifier that has the format US:AAAEQ##TXXXX. The digits represented by ## are the REN without a decimal point (e.g., 03 is a REN of 0.3).

If this equipment causes harm to the tele- phone network, the telephone company will notify you in advance that temporary discontinuance of service may be required. But if advance notice isn't prac- tical, the telephone company will notify the customer as soon as possible. Also, you will be advised of your right to file a complaint with the FCC if you believe it is necessary. The telephone company may make changes in its facilities, equipment, operations or procedures that could affect the operation of the equipment.

If this happens the telephone company will provide advance notice in order for you to make necessary modifications to maintain uninterrupted service.

Please follow instructions for repairing, if any (e.g. battery replacement section); otherwise do not substitute or repair any parts of the device except as specified in this manual. Connection to party line service is subject to state tariffs. Contact the state public utility commission, public service commission or corporation com- mission for information. This equipment is hearing aid compatible.

If you experience trouble with this equip- ment, contact the manufacturer (see the cover of this manual for contact informa- tion) or an authorized agent. If the equip- ment is causing harm to the telephone network, the telephone company may

request that you disconnect the equip- ment until the problem is resolved.

If your home has wired alarm equipment connected to a phone line, be sure that installing the system does not disable your alarm equipment. If you have questions about what will disable alarm equipment, contact your telephone company or a qualified installer.

Any changes or modifications to this product not expressly approved by the manufacturer or other party responsible for compliance could void your authority to operate this product.

NOTICE: According to telephone com- pany reports, AC electrical surges, typi- cally resulting from lightning strikes, are very destructive to telephone equipment connected to AC power sources. To mini- mize damage from these types of surges, a surge arrestor is recommended.

FCC Part 15 Information

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and

(2)This device must accept any interfer- ence received, including interference that may cause undesired operation. Privacy of communications may not be ensured when using this phone.

FCC PART 15.105(b): Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equip- ment does cause harmful interference to

English - 22

Image 22
Contents You will also find D1685 Series Users GuideWhats in the box? If You Contact Uniden’s Phone NumberImportant Safety Instructions What’s in the manual?Installing Your Phone Getting StartedGetting to Know Your Phone Parts of the BaseXx In standby decrease the ringer volume Xx In standby increase the ringer volumeXx When entering text move the cursor to the right Xx During a call switch to a waiting callParts of the Handset Icon Reading the DisplayOn the Base Handset Only IconsMenu Functions Using the MenusBasic Menu Operation Menu Option What it doesEntering Text on Your Phone Using Your PhoneRegister Accy. Menu Base Only From Base From Handset Speakerphone EarpieceChanging the Volume Using the Caller ID and Redial ListsUsing the Phonebook Using Call WaitingAdding Phonebook Entries Multistation Features Using Special FeaturesSilent Mode Phone exits silent modeIntercom Privacy ModeCall Transfer From the base From a cordless handsetChain Dialing Setting Up Chain DialingUsing Chain Dialing Voice Message NotificationAnswering System Options Ans. Setup Using the Answering SystemRecording the Outgoing Message Follow these steps from the base or a handset Accessing the Answering SystemGetting Your Messages From the base From a handsetScreening Your Calls Using the System While Youre Away from HomeProgramming a Security Code System hangs up and returns to Solving ProblemsImportant Information StandbyMultistation problems Possible solutions Answering system problems Possible solutionsCharge the battery completely, then try again Installing a Line Filter or DSL FilterResetting Stations Liquid DamageBattery pack with normal use Adapter and Battery Infor- mationRechargeable Battery Warning FCC Part 68 InformationFCC Part 15 Information Industry Canada I.C. Notice FCC RF Exposure InformationStar is a U.S. registered mark