NOTE: Use only the Uniden Battery
Battery use time (per charge)
From fully charged
•Seven hours continuous use
•Fourteen days when the handset is in the standby mode
Low Battery Alert
When the battery pack is very low and needs to be charged, the phone is programmed to eliminate functions in order to save power. If the phone is not in use, the talk/batt low LED flashes when the battery pack is low.
If the phone is in use, the talk/batt low LED flashes and the handset beeps. Complete your conversation as quickly as possible and return the handset to the base for charging.
Cleaning the Battery Charging Contacts
To maintain a good charge, it is important to clean the battery contacts on the handset and base unit with a dry cloth or a pencil eraser about once a month. Do not use any liquids or solvents.
NOTE: Even when the battery pack is not being used, it will gradually discharge over a long period of time. For optimum performance, be sure to return the handset to the base unit after each telephone call.
C. Connect the base unit
1) Connect the AC adapter to the DC IN 9V jack and a standard 120V AC wall outlet.
2) Wrap the cord inside the molded wiring channel as shown.
3) Set the base unit on a desk or tabletop, and place the handset in the base unit.
4) Make sure the status LED illuminates. If the LED does not illuminate, check to see that the AC adapter is plugged in and the handset makes good contact with the base charging contacts.
NOTICE: Place the power cord so it does not create a trip hazard or where it could become chafed and create a fire or electrical hazard.
NOTES: • Use only the supplied
•Connect the AC adapter to a continuous power supply.
•Place the base unit close to the AC outlet so that you can unplug the AC adapter easily.
After installing the battery pack in the handset, charge your handset at least
3