Location of Controls, Radio Operations

LOCATION OF CONTROLS

Front View (Door Close)

Front View (Door Open)

RADIO OPERATIONS

1.Slide the FUNCTION selector to Radio mode.

10 11

7 6 5

2.Slide the AM/FM BAND selector to select desired radio band. 3.Rotate the TUNING dial until the desired broadcasting is received. 4.Rotate the VOLUME dial to adjust the sound level.

REMINDER :

Make sure the FUNCTION selector at OFF position when the radio is not in use.

TIPS FOR THE BEST RECEPTION :

To obtain the best AM/FM reception, slightly rotate the unit until the clearest signal is received or place it near outdoor.

NOTE :

Rear View

23
	20
	19
22	21

1.FUNCTION SELECTOR: POWER OFF; Select iPod/ RADIO/ AUX modes.

2.AM/FM RADIO BAND SELECTOR: Select between FM STEREO/FM(mono)/AM.

3.VOLUME DIAL: Adjust the volume level up or down.

4.TUNING DIAL: Adjust the radio channel frequency up or down.

5.iPod PLAY/PAUSE BUTTON
6.iPod SKIP / SEARCH FORWARD	BUTTON
7.iPod SKIP / SEARCH BACKWARD	BUTTON
8.LCD DISPLAY

9.TIME SET BUTTON: Select clock setting mode.

10.HOUR BUTTON: Set hour value of clock.

11.MIN BUTTON: Set minute value of clock.

12.iPod DOCKING COMPARTMENT 13.COMPARTMENT DOOR LOCK 14.SPEAKERS

15.iPod DOCKING CONNECTOR

16.AUX IN ----An Audio Cable with a 3.5mm stereo plug for the connection of external audio device.

17.FOLDING PLATFORM ----A sitting platform for the external audio device.

18.CLOCK BATTERY COMPARTMENT

19.DC JACK ----To connect to external DC power supply.

20.STEREO HEADPHONES JACK

21.MAIN BATTERY COMPARTMENT ----To install main batteries for the Radio / Speaker operation.

22.DETACHABLE STAND ----A plastic stand for the desk top sitting.

23.ROPE HOLDER ----For attaching hanger rope.

(1)When weak FM radio signal is received, the unit will automatically switch to FM mono mode even if the BAND selector is set at the FM stereo position.

(2)The iPod may cause interference to the AM reception if it is docked and turned ON. You should turn off the iPod manually or remove it from the unit for better reception.

(3)Due to the use of high efficiency AC adaptor in this product, it may cause some interference to AM radio. We strongly recommend you use battery when listening to AM.

IPOD® DOCKING

1.Release the iPod DOCKING COMPARTMENT DOOR LOCK. 2.Open the compartment door.

3.Insert your iPod with its connector faced downward and directly over the dock connector inside the compartment.

CAUTION : Please be careful when seating the iPod into the docking to avoid damaging the 30-pin connector on iPod or the docking system.

4.Close and lock the compartment door.

5.Slide the FUNCTION selector to iPod position. The iPod will start playing automatically. 6.Rotate the VOLUME dial to adjust volume to your desired level.

NOTE : The volume level cannot be adjusted by the volume of your iPod after being docked.

7.The iPod is charging even in playback state.

NOTE : The iPod recharge function operates in iPod and AUX modes when the unit is powered by external AC adaptor. When the unit is operated by the main battery alone, the iPod recharge function disabled.

8.To remove the iPod from the unit, press and hold the PLAY/PAUSE button for three seconds to switch off the device and then gently take the device out.

You may control the playback of your iPod by :

- Press the PLAY/PAUSE button to pause or resume the iPod playback.

-Press the SKIP/SEARCH FORWARD or BACKWARD button to skip to next or previous song.

-Press and hold the SKIP/SEARCH FORWARD or BACKWARD button for fast-forwarding or fast-rewinding during playback.

NOTE : To avoid water damage inside the docking compartment or water damage to your iPod, please make sure your hands are dry and you only open the docking compartment when you are not near water. It is important to tightly lock the compartment door properly before using near water.