Mattel BAR201 owner manual Getting Started, Unpacking and SET UP

Page 6

GETTING STARTED

• Operate controls and switches as described in the manual.

• Before turning on the power, make certain that the AC Power cord is properly installed.

• Store your CDs in a cool area to avoid damage from heat.

• When moving the unit, be sure to first disconnect the AC Power cord.

UNPACKING AND SET UP

• Carefully remove the main unit and the AC Power cord from the display carton. Remove all the packing material from the unit. Remove any decorative or descriptive labels from the front or top of the cabinet. Do not remove any labels from the back or bottom of the cabinet.

• Carefully remove any small strips of tape that may have been used to prevent the CD door from opening in transit.

• Unwind the AC Power cord and extend it to its full length.

• This unit was shipped with a dummy CD transit card in the CD player. This dummy CD prevents the laser pick up from moving during shipment. This card must be removed before you can insert your own CDs. Lift the CD Door OPEN Tab to open the CD door. Carefully remove the dummy CD from the player and discard it. Close the CD door.

• Place the unit on a flat, level surface such as a table, desk, counter, shelf, etc, convenient to a 120V 60 Hz AC outlet, out of direct sunlight, and away from sources of excess heat, dust, moisture, or strong magnetic fields.

5

Image 6
Contents BAR201 Safety Precautions FCC Warning FCC Information Protect Your Furniture Page Unpacking and SET UP Getting StartedTop of Unit Front/Side of Unit Battery Installation AC Operation Listening to the Radio AntennasVolume To Insert and Play a CDPlease see Notes on the Next To Pause PlaybackAUX in Jack To Cancel or Stop Repeat Playback To Repeatedly Play Back ONE TrackTo Repeatedly Play Back ALL Tracks To Program the Memory UP to 20 Tracks Step Caring for Compact Discs Care of the CabinetSymptom Cause Solution Emerson Radio Corp CARRY-IN Parts & Labour Warranty Periods BAR201-081207-02