
The Radio
Normal tuning |
|
|
| Preset tuning | ||||||||
3 | 2 | 1 | 5 | 4 |
| Preset the stations (twelve FM and twelve AM) to make tuning simpler. | ||||||
1 2 4 | 3 |
|
| |||||||||
|
|
|
|
|
|
|
|
| ||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
1 Switch [] to “TUNER”. (Unit comes on.)
2 3 1
How to preset
Preparation: Tune to the desired station. (Do steps
2 | Press [BAND] to select “FM” or “AM”. | |||
3 | (Omit this step if using the remote control) | |||
| If “ | ” is on the display, press | ||
| [TUNE MODE] to clear it off. |
|
| |
4 | Press |
|
| |
| tune to the desired station. |
|
| |
| The frequency changes one step |
|
| |
| each time a button is pressed. | “ ” lights when an FM stereo | ||
| Automatic tuning | broadcast is being received. | ||
|
|
|
Keep
To stop automatic tuning, press
Note
Automatic tuning may stop on a frequency where there is no station if there is interference. Press
5 Adjust the volume.
To use auto scan
You can search for a station by listening to all
Preparation: Switch [] to “TUNER”.
1.Press [BAND] to select “FM” or “AM”.
2.Press [AUTO SCAN]. Auto scan starts.
Indicates auto scan
3. Press [AUTO SCAN] when you find the desired station.
Auto scan ends when it reaches the original frequency again. To stop during the process, press [AUTO SCAN].
To improve reception
1 Press [MEMORY].
2 While “” and the frequency are flashing
Press [MEMORY].
Preset channel
3 While “” and the preset channel are flashing
Press
(Remote control: [4] or [3])
4 Press [MEMORY].
(This completes presetting.)
Repeat the above to preset other stations.
Note
1If “ ” goes off during presetting, return to step 1.
To listen to preset channels
2Press [BAND] to select “FM” or “AM”.
(Omit this step if using the remote control)
Press [TUNE MODE] to display
3“”.
Press
(Remote control: [4] or [3])
Preset channel
FM: Extend the whip antenna and adjust its direction.
AM: Adjust facing of the unit.
If noise is excessive in the FM stereo mode
Press [FM MODE]. (“ ” lights up.)
Sound will be produced in monaural, but this also reduces noise.
Press the button again to cancel. (“ ” goes out.)
To use preset scan
You can search for a station by listening to all preset channels for 8 seconds each.
1. Do steps 1to 2above.
For remote control, replace
2. Press and hold
Indicates preset scan
3. Press
Preset scan ends after searching through each preset channel once. To stop during the process, press
3
RQT6341
3 | 11/21/01, 7:05 PM |