Sequential Play

Basic Play

Decrease	Increase
		S-XBS TRAIN
VOL	RANDOM 1 M
VOL	C	VOL
	C

Track number in play

S-XBS TRAIN

RANDOM 1 M

CVOL

LL
LL
A	E
C	E
E	D
Y/	O
R	M
R	M
O
EM
M

1 OPEN

Label must face upward.

Close the lid.

Elapsed playing time of each track	HO
Elapsed playing time of each track	L
	D

OPEN

3 HOLD

SL-SX390

VOL

Plug type:

3.5 mm (1/8 in.) stereo

HOLD

OPEN

R L

Follow steps 1–5.

In step 2: Connect the stereo headphones/earphones and wired remote control (SL-SX390) to the headphone jack [Ë]. (Plug in firmly.)

In step 5: The volume range is 0-25. Press and hold to change the volume successively. The volume changes when pressed while the level is displayed. If any other display is shown, it changes to show the current level. (The volume returns to 10 when you disconnect the power source.)

≥Play stops automatically when all the tracks have been played.

≥If the unit has been connected to the car audio system, set this unit’s volume to 10, then adjust the volume level on the system.

For your reference: “)” indication

This indication appears for about 30 seconds if [1/;] is pressed when no disc is loaded in the unit or if the disc is not properly secured.

“*” indication

This indication appears for about 10 minutes when the cover is opened. (However, the indication does not ap- pear when the unit is powered off.)

Operation

To pause play

To stop play

Stop mode

To turn off the

unit Off mode

Skip forward/

backward

(skip function)

Rapid forward/

backward

(search function)

Button

Press during play.

Resume function

Play starts from the beginning of the current track the next time you press [1/;].

Press during stop mode.

Press during play.

(Press [:] twice to skip to the beginning of the previous tracks.)

Backward

Forward

Press and hold during play.

Display/reference

Press again to restart play.

S-XBS TRAIN

RANDOM 1 M

CVOL

Total number of tracks

S-XBS TRAIN

RANDOM 1M

CVOL

Total playing time

No indicator is shown.

S-XBS TRAIN

RANDOM 1 M

CVOL

≥During program play (page 4), these buttons are used to skip forward or backward through the programmed sequence of tracks.

≥You cannot skip to tracks that have been played in random or random repeat play (page 4).

≥During program play, 1-track repeat play, random play and random repeat play (page 4), search op- eration is limited to the current track only.

Removing discs

1Press [∫] to stop play and disc rotation.

2Slide [OPEN 1] to open the lid.

3Press [PUSH] to release the disc.

Do not stop the disc by hand or try to remove it before it stops rotating. This can damage CDs.

HSUP

PUSH

HOLD

OPEN

Note!

Never insert foreign objects into the unit.

Auto power off function

If the unit is left in stop mode for approximately 10 min- utes, the unit powers itself off automatically in order to prevent the battery from running down.

(If no disc is loaded in the unit, it powers itself off in about 30 seconds.)

Note on CD-R and CD-RW

This unit can play CD-DA format audio CD-R and CD-RW that have been finalized§ upon completion of recording. It may not be able to play some CD-R or CD-RW due to the condition of the recording.

§Finalizing is a process that enables CD-R/CD-RW players to play audio CD-R and CD-RW.

Resume function notes

≥Opening the lid while in the stop mode or replacing the disc while in the off mode cancels the function. (It may re- main active if you replace a disc in the off mode.)

≥Play may resume from the beginning of the next track if you stopped play near the end of a track. ≥The resume function works automatically and cannot be turned off.