
Installation (continued)
Mounting and removing the Main Unit
❏Mounting Procedures (When using Mounting Collar w)
Note: | IMPORTANT |
¡The car model, installation conditions and combination of the units used may impose some restrictions on oper- ating position.
When this unit is installed in dashboard, ensure that there is sufficient air flow around the unit to prevent damage from overheating. Do not block any ventilation holes on the unit.
| q |
q |
|
| w |
| e |
w |
|
e |
|
r | r |
t | t |
|
Insert the Mounting Collar w into the dash- board, and bend the mounting tabs out with a screwdriver.
Establish the rear connection of the unit.
After fixing Power Connector, fix the rear of the unit to the car body by either method (a) or (b).
Insert the unit into Mounting Collar w.
Secure the clamp plate of Mounting Collar w to the hook.
Snapping point
Insert Trim Plate q.
After installation reconnect the negative
Method for Fixing the Rear of the Unit
(a) Using the rear support strap e
(b) Using the rubber cushion (option)
uPlain Washer iSpring Washer
yHex. Nut
Fire Wall of Vehicle
tHex. Bolt
(5 mmø x 25 mm)
oToothed Lock Washer
yHex. Nut (5 mmø)
iSpring Washer
uPlain Washer
eRear Support Strap Mounting Bolt (5 mmø)
Rear support bracket
Rubber cushion (option) (provided on the vehicle)
Mounting bolt (5 mmø)
w Mounting collar
wMounting Collar