iHome IP98 manual Replacing iP98 Backup Batteries, Radio

Page 6

Using the iP98

Radio

Setting up Antennas

a)Snap AM loop antenna into provided stand, then plug AM antenna cable into AM Loop Antenna socket on back of unit. Move antenna 12” away from unit for best reception.

b)Extend FM Antenna (on back of unit) fully for best reception. Do not strip, alter or attach to other antennas.

Tuning and Playing the Radio

a)Press the Radio Button to select radio play mode. Press as needed to select FM or AM radio band.

b)Turn the Set Wheel to tune radio to a desired station.

c)To program the current station as a preset, press and hold Preset Button 1-2until P1 flashes on display; press again for P2 and allow to time-out (beep confirmation). Repeat steps a,b,and c for other preset buttons to preset up to 12 stations (6 AM, 6 FM). To listen to a preset station at any time, simply press the desired preset button once or twice.

d)Turn the Volume Wheel to adjust iP98 volume up or down.

e)Press the EQ Button to select Treble, Bass, 3D sound effect or Balance. Turn the Set Wheel to adjust settings. EQ settings for iPod and radio mode are independent.

f)Press Button to turn iP98 off.

Using the Line-in Jacks

a)Use an audio patch cord (available at www.ihomeaudio.com) to play nondocking iPods or other audio devices through the iP98 Line-in Jack (connect one end in the device’s line out or headphones jack, the other in the iP98 line-in jack).

b)To listen to your audio device, press the Radio Button until line-in is displayed, indicating line-in mode. Adjust the output volume on your line-in device.

Using Sleep Mode

Sleep mode lets you sleep to your iPhone/iPod or the radio, gradually lowering the volume until the unit shuts off at the selected time.

a)Press the Sleep Button to select an amount of time before the iP98 shuts off: 120, 90, 60, 30 or 15 minutes.

b)Turn the Volume Wheel to set the sleep volume (this volume setting is separate from your standard volume setting).

Using the Dimmer

a)Press the Snooze/Dimmer Button during normal operation to adjust brightness of LCD display. There are 8 levels of brightness including OFF.

Replacing iP98 Backup Batteries

Install/Replace Backup Battery

The iP98 uses a backup battery system to provide continuous alarm operation and clock settings in the event of a power failure. If the Battery Low Icon located on the right of the display is flashing, it is time to replace the backup batteries. Please make sure the AC adaptor is connected, otherwise all settings may be lost during battery replacement.

Open the battery compartment cover located on the bottom of the unit. Insert 2 “AA” batteries as indicated. We recommend the use of alkaline batteries for longer life.

Batteries information:

• Do not mix old and new batteries.

• Do not mix alkaline, standard (carbon -zinc) or rechargeable (nickel-cadmium) batteries.

4

Image 6
Contents Home System For Your iPhone or iPod Consumer Guide to Product Safety Table of ContentsQuick start Controls and Indicators IP98 DisplayUsing the iP98 Connect iP98 to Power SourceReplacing iP98 Backup Batteries RadioUsing The Remote Control Unit Install/Replace the Remote Control BatteriesConsumer Guide to Product Safety Troubleshooting Symptom Possible Problem SolutionTry turning bass boost OFF Solucionando problemas Síntoma Causa SoluciónLa banda de AM se Limited 1 Year Warranty Information