Radio

Radio reception

• Switch the radio on and off with the button.

-The frequency and the wave band will appear on the display.

•Select the desired waveband with the BAND SELECTOR switch.

•Adjust the volume by turning the VOLUME CONTROL.

Aerials

•For FM reception extend the telescopic aerial fully. To improve the reception you can incline and rotate the aerial. If the FM signal received is too strong (in direct vicinity of the transmitter) you can retract the aerial.

•For MW and LW reception, the set has a built in aerial, so the telescopic aerial is not needed. You can direct the aerial by turning the radio.

•For short wave reception (SW) extend the telescopic aerial and position it vertically.

Selecting distant or local

•Slide the DISTANCE/LOCAL selector to the LOCAL position to reduce interference and distortion when listening to strong FM or SW stations. This causes the signal to be weakened, thus reducing interference.

The switch should normally be left in the DISTANCE position.

Automatic tuning

•To activate automatic station search (auto tuning), press

+ or - until the frequency display begins ‘to run’, then release the button. -The search stops as soon as a station is located. -Stations which are received with a weak field strength

may be skipped. These can be tuned manually by pressing the + or - button.