Using the iH56

Connect iH56 to Power Source

a) Plug the AC adaptor cable into the AC Adaptor Jack and the other end into a standard 120v wall socket. The iH56 does not

operate on batteries.

Setting the Clock

a) Press and hold the Time Zone Button until the display flashes.

b)Turn the Set Wheel to select your time zone.

c)Press the Time Zone Button again. The clock will display the current time in your time zone.

d)	To adjust the time for Daylight Saving Time, slide the DST switch to +1 to advance the time 1 hour.
	Slide to -1 to turn the clock back 1 hour.
To Set Clock Manually
a)	Press and hold the Clock Adjust Button. The clock display will flash.

b)Turn the Set Wheel until the current time is displayed (a PM indicator appears when time is set to PM; there is no AM indicator).

c)Press the Clock Adjust Button to accept the time. The year display will flash.

d)Turn the Set Wheel to adjust the year and press the Clock Adjust Button. The date display will flash.

e)Turn the Set Wheel to adjust the date and press the Clock Adjust Button. Two beeps will indicate clock setting is complete.

Using the Alarm

Setting the Alarm

a) Press and hold the Alarm Set Button until the alarm time flashes.

b)Turn the Set Wheel to set the alarm time (a PM indicator appears when time is set to PM; there is no AM indicator).

c)Press Alarm Set again. Alarm is now armed, indicated by the alarm clock icon and alarm source icon.

d) At any time, press the Wake-To Button repeatedly to select an alarm source to wake to: iPod, radio or buzzer.

Turning Alarm Function ON and OFF

a) Press the Alarm On/Off Button to arm or disarm alarm function. When armed, alarm icon appears in display.

Resetting the Alarm to Come on the Next Day

a) When the alarm is sounding, press the Alarm Reset/Power Off Button to stop alarm and reset it to come on the following day.

Snooze

a)Press the Snooze/Dimmer Button after the alarm sounds. The alarm will be silenced and come on again 9 minutes later. Snooze can be pressed several times during the 1 hour alarm cycle.

Sure Alarm

The iH56 has a sure alarm feature so in the event of a power failure, the buzzer alarm will still sound (if backup batteries are installed).

iPod

Playing and charging your iPod

a) Place proper insert for your iPod (see insert table on page 1) in Dock, then gently dock iPod. When docked, iPod will charge until fully charged. The iPod will not overcharge. Note: To remove insert, use thumbnail in slot on back of insert and pull up.

b) Press the iPod Button to play iPod, and again to pause.

c) Turn	Volume Wheel to adjust iH56 volume up or down
d) Press	Alarm Reset/Power Off Button to turn iH56 and iPod off.