Setting up Antennas, Tuning and Playing the Radio

Using the iH56

Radio

Setting up Antennas
a)	Snap AM loop antenna into provided stand, then plug antenna cable into	AM Loop Antenna socket on back of unit.
	Move antenna 12” away from unit for best reception.
b)	Extend FM Antenna (on back of unit) fully for best reception. Do not strip, alter or attach to other antennas.

Tuning and Playing the Radio

a)Press the Radio Button to select radio play mode.

b)	Press the AM/FM Select Button to select AM or FM radio band.
c)	Turn the Set Wheel to tune radio to desired station.
d)	Turn the	Volume Wheel to adjust iH56 volume up or down.
e)	Press	Alarm Reset/Power Off Button to turn iH56 and iPod off.

Using the Line-in and Line-out Jacks

a)Use an audio patch cord (available at www.ihomeaudio.com) to play nondocking iPods or other audio devices through the iH56 Line-in Jack (one end in the device’s line out or headphones jack, the other in the iH56 line in jack). Make sure there is no iPod docked in the iH56 when using the line-in jack. Press the iPod Button until AUX appears on the display.

b) Use the

Line Out Jack to connect the iH56 to the line-in jack of other audio devices such as a tape recorder or amplifier.

The Volume Wheel of the iH56 does not control line-out volume (adjust on attached device instead).

Using Sleep Mode

Sleep mode lets you sleep to your iPod or the radio, gradually lowering the volume until the unit shuts off at the selected time. a) Press the Sleep Button to select an amount of time before the iH56 will turn off: 120, 90, 60, 30 or 15 minutes.

b) Turn the Volume Wheel to set the sleep volume (this volume setting is separate from your standard volume setting).

Using Dimmer

a) Press the Snooze/Dimmer Button during normal operation to adjust brightness of LCD display.

Changing the Speaker Grille

The iH56 comes with 3 detachable speaker grilles (one is already installed).

a) To remove the speaker grille, grip the bottom edge of the grille on either side and gently pull forward until the bottom edge is free of the unit. Grip the the left edge of the grille and gently pull out the grille from the left of the unit. Do the same on the right and release the grille.

b) To replace the speaker grille into the unit, simply line up the grille and press firmly into place. Make sure the grille is placed properly so it does not vibrate.

NOTE: DO NOT TOUCH EXPOSED SPEAKERS WHEN GRILLE IS

REMOVED