Listening to non-docking iPod or other audio devices
1.Plug one end of an audio cable (available at www.ihomeaudio.com) into the headphone or
2.Press the 
button on the right speaker to turn the iH70 on.
3. | Press the or Buttons on the right speaker to adjust the system volume. You may need to adjust your device volume, |
| too. |
4. | To turn off the iH70, press the button on the right speaker. Please remember to turn off your device, too. |
Listening to Headphones
The iH70 has a headphone jack located on the left side of the left speaker.
1.Plug the end of your headphone cable into the headphone jack.
2.Adjust the volume using the 
or
Buttons on the right speaker.
NOTE: Output from the speakers is disabled when headphones are in use
Syncing your iPod to a Computer through iH70
The iH70 allows you to sync your docked iPod with a computer directly from the iH70 without removing the iPod.
1.Plug the USB cable into a powered USB port on your computer and the other end to the iH70’s USB port located on the back of the left speaker.
2.Make sure the iPod is properly docked. Press the Sync Button located on the back of the left speaker. A green LED on the top of the left speaker will light up to indicate computer sync mode is active. The unit will take a few seconds to start syncing with iTunes. When an iPod is syncing, DO NOT undock your iPod or press the Sync Button. During computer sync mode, you cannot control your iPod through the iH70 remote.
3.Once syncing is completed, you must eject your iPod through iTunes before pressing the Sync Button to exit sync mode.
When an iPod is syncing, DO NOT undock your iPod or press the Sync Button
4