Manual tune - FM
1.Fully extend the wire aerial located on the rear of your clock radio. Place the wire antenna so that it is as straight as possible extending either above or below the radio.
2.Press the On / Standby button to switch on your clock radio.
3.Press the Band button to select the FM band.
4.Press the Tuning Up or Down buttons to tune to a station. The frequency will change in steps of 50kHz. Pressing and holding the buttons will advance the frequency several times each second.
If the radio is tuned to a station of sufficient signal strength with RDS information present, then the display may change to show the station name.
5.When the end of the waveband is reached the radio will recommence tuning from the opposite end of the waveband.
6.Set the Volume to the desired setting.
7.To switch off your clock radio press the Standby button.
Note: The display will revert to a conventional time display 10 seconds after the last button press except when displaying scrolling text.
13
2,7
3
SNOOZE
down | TUNING | up |
44
6
VOLUME