Setting Times, Alarm time display, CD Playback

SETTING TIMES

The time is displayed using the 12 hour clock (PM indicator lights up = PM, off = AM).

1.Press and hold down

TIME/ ALARM until the clock or alarm time display flashes, then release

•Press TIME/ ALARM repeatedly to toggle between the time or alarm displays

2.Press and hold down ° / ¤ to fast adjust both the hours and minutes settings.

3.Release ° / ¤ when you

have reached the desired setting. yIf you need to adjust

the time slowly, minute by minute, press and release ° / ¤ repeatedly.

yAfter several seconds, the time setting is confirmed when the display stops flashing.

4.Repeat steps 1-3 for each of the clock or alarm (AL1, AL2) settings.

If you have set both alarms, the standby alarm time display will show the earlier of the two alarm times as priority.

E.g. if AL1 = 6:00 and AL2 = 5:45, then the standby alarm display will show the AL2 time 5:45.

1.Insert a CD with the printed side facing up, and close the door.

2.Press PLAY/ PAUSE 2; to start playback. yDisplay shows:

'Cd: --' and the total

number of tracks, then your current track number, before returning to clock time.

Other possible CD indications before returning to clock time:

ydoor is shown if the CD door is not closed. ynoCd is shown if no CD has been inserted /

inserted incorrectly.

ynFCd is shown if the CD-R(W) is non- finalized

yErr indicates a general error in operation of the set.

3.Adjust the sound with 4 or 3.

4.To interrupt, press 2;

yCD icon flashes.

5.Press 2; again to resume playback.

6.Press ALARM RESET to stop playback.

Note: If CD playback is paused for more than 15 minutes and no controls are pressed, the set automatically goes to standby mode.

The track number appears briefly in the display when you press ° or ¤ to skip tracks.

•Press ¤ once or more to skip to the next track(s).

•Press ° once and playback will return to the beginning of the current track.

•Press ° more than once to skip to previous tracks.