Operating your radio - Search tuning FM
1.Place the wire antenna so that it is as straight as possible extending either above or below the radio.
2.Press the Standby button to switch on your radio.
3.Press the Band button to select the FM band.
4.Press and immediately release the Auto tune button, your radio will scan in an upwards direction (low frequency to high frequency) and stop automatically when it fi nds a station of suffi cient strength.
5.After a few seconds the display will update. The display will show the frequency of the signal found. If the signal is strong enough and there is RDS data present then the radio will display the station name.
6.To fi nd other stations, press and release the Auto tune button as before.
7.To scan the FM band in a downwards direction (high frequency to low frequency) press and hold down the Auto tune button for 0.5 seconds and then release.
8.When the waveband end is reached your radio will recommence tuning from the opposite waveband end.
9.Adjust the Volume and Tone controls to the required setting.
10.To switch off your radio press the Standby button.
2
3
4
6,7
9 | 9 |
21