Roberts Radio R9957 manual Operation via an AC adaptor not included

Page 6

Operation via an AC adaptor (not included)

The AC adaptor for use with the R9957 should provide 3 volts DC output at 300mA centre pin positive.

1.Place your radio on a ﬂ at surface.

2.Pull back the rubber protection cover from the DC input socket.

3.Plug the adaptor lead into the DC input socket located on the left hand side end of your radio ensuring that the plug is pushed fully into the socket. The batteries will be automati- cally disconnected.

4.Plug the adaptor into a wall socket and switch on.

Image 6

Contents R9957 Controls Top Controls Front Controls Rear Battery operation Operation via an AC adaptor not included Using Dynamo power Charging your radioTuning indicator will light Listening to your radioLamp operation Emergency buzzerHeadphones GeneralSpeciﬁcations Circuit Features Power RequirementsGuarantee