Roberts Radio R9999 manual General, Mains supply, Fuse

Page 22

General

Do not allow this unit to be exposed to dripping or splashing. Do not leave your radio where excessive heat could cause damage such as in a parked car where the heat from the sun can build up even though the outside temperature may not seem too high. It is recommended that the FM band be used where ever possible as better results in terms of quality and freedom from interference will usually be obtained than on the MW or LW bands.

The nameplate is located on the underside of your radio.

Mains supply

The R9999 will operate from a supply of AC 230 volts, 50Hz only.

DO NOT cut off the mains plug from this equipment. If the plug fitted is not suitable for the power points in your home or the cable is too short to reach a power point, then obtain an appropriate safety approved extension lead or adaptor. If in doubt consult your dealer.

If nonetheless the mains plug is cut off, remove the fuse and dispose of the plug immediately to avoid a possible shock hazard by inadvertent connection to the mains supply.

If this product is not supplied with a mains plug, or one has to be fitted, then follow the instructions given below:

IMPORTANT. DO NOT make any connection to the larger terminal which

is marked with the letter E or by the safety earth symbol or coloured

Green or Green-and-yellow.

The wires in the mains lead are coloured in accordance with the following codes :-

BLUE - NEUTRALBROWN - LIVE

The wire coloured BLUE must be connected to the terminal marked N or coloured BLACK.

The wire coloured BROWN must be connected to the terminal marked L or coloured RED.

Fuse

When replacing the fuse only a 3A ASTA approved to BS1362 type should be used and be sure to re-fit the fuse cover.

IF IN DOUBT - CONSULT A QUALIFIED ELECTRICIAN.

Replacement fuse holders are available from Roberts Radio Technical Services at the address shown on the rear of this manual.

The rating plate is located on the underside of your radio..

21

Image 22
Contents R9999 Important Information please read before use Automatic Plug and Play setup Controls Top LCDHeadphone socket on side Mains socket Battery compartment Controls RearDisplay Battery operation Mains operationSetting the clock automatically Setting the clock manually Setting the day of week manuallyDisplaying the alarm time Setting the alarm timeWake to buzzer Wake to radio Sleep timerSnooze control Weekend alarm cancel Operating your radio search tuningOperating your radio manual tuning Pre-setting stations Recalling a preset station Last station memoryProgramme Identification PI Clock Time CT automatic adjustmentProgramme Service PS name Traffic Information SystemDisplay Modes Operating your radio using RDS Radio data systemAlternate Frequency AF Programme type display PTY Programme Type search PTY Traffic Announcements TAPage Headphones Demonstration modeDisplay backlight Mains supply GeneralFuse Specifications TroubleshootingCircuit Features Roberts Radio Technical Services Department