studs
screws
mounting
bracket
16”
ITP180B
ITP180B
spacer
Getting Started
1Use the Tape Measure to decide how high you’d like to hang the bar speaker on the wall.
The bar speaker must be hung within 6 feet of an AC power outlet for the attached AC power cable to reach.
2Use the Stud Finder to locate 2 parallel wooden studs to screw the mounting brackets into.
3Mark the wall at the center of the studs using the pencil.
4Line the level up on both of your marks to make sure they are level. If they’re not, adjust the marks as needed to make them level.
5After you’ve double checked your markings, drill through the top hole on both mounting brackets directly into the marks you’ve made on the wall.
6If you are using the brackets only and no spacers, use the included short screws. If you are using any of the spacers or combination of the spacers, use the long screws.
7Use the Level to level each of the hanging brackets, then drill the second screw into the bottom hole on both mounting brackets.
8Slide the bar speaker onto the mounting brackets, and make sure there is a firm and stable connection before letting go of the bar speaker.
9Finally, use the Level to confirm that the bar speaker is level.
CUSTOMER HELPLINE | iLive ITP180B 15 |