Extron electronic manual Mounting the SI 3 speaker onto the wall mount assembly

Page 9

Anchor this end to a suitable secure point.

Seismic Safety Cable

Attach cable here and secure it.

Figure 9 — Attaching a seismic safety cable to the rear of the speaker

Mounting the SI 3 speaker onto the wall mount assembly

3.	Carefully lift the speaker above the wall mount assembly
	and gently slide the speaker box bracket down into the
	V-Lock groove (see figure 10) until it locks into place.

Box

Bracket

V-Lock

Groove

...and slide it down into the V-lock groove.

Lift the speaker up to the

wall mount assembly....

Box

Bracket

V-Lock

Groove

Figure 10 — Sliding the speaker down onto the wall mount assembly

4.Repeat steps 1 through 3 for the second speaker, then proceed to "Wiring the speakers" section.

SI 3 Speakers • Installation

7

Image 9

Contents Compact Full Range Surface Mount Speakers SI 3 System IntegratorSI 3 speaker packaging details Packaging InformationAbout the SI 3 Speakers IntroductionFeatures FeaturesInstallation Installing the SI 3 SpeakersDesktop or bookshelf applications Installation, cont’d Installing the wall mount assemblyWall mounting applications Installing the wall mount assembly Preparing the speaker for mounting Do not strip and connect the wire at this timeLock groove see until it locks into place Mounting the SI 3 speaker onto the wall mount assemblyExtron Wiring the speakersTo remove the grill Service AccessTroubleshooting Tips Troubleshooting TipsSecuring the grill optional SI 3 Speakers Troubleshooting Tips Observed Problem Possible Causes Remedial ActionSpecifications Audio/acoustic and electricalGeneral Central America Extron’s WarrantyExtron Electronics, Europe Beeldschermweg 6C