Listening To The Radio
1.) Press the 
POWER button to turn the unit ‘On’.
The display lighting comes ‘On’ and the display briefly shows “HELLO”.
2.) Press the FUNCTION button to select the TUNER function.
An AM or FM frequency will appear on the display.
Press the TUNER/BAND button again to switch between the AM and FM bands if necessary.
3.) Tune to the desired station as follows:
•Manual Tuning
Repeatedly press the 
or 
SKIP/TUNING buttons until the display shows the exact frequency of the desired station. Use the Manual Tuning method to tune to weak or distant stations that are not strong enough to be recognized by the Automatic Tuning system.
•Automatic Tuning
Depress and hold the 
or 
SKIP/TUNING buttons until the display begins to move, then release the buttons. The Tuner will search up or down the band for the next strong signal and stop on that station. Repeat this procedure until the tuner stops on your desired station.
4.) If you tuned to an FM Stereo station the ST indicator will appear in the display. If the FM Stereo reception is noisy or weak, press the MODE/FIND button on the remote control to select the FM Mono mode.
5.) Adjust the VOLUME, DBBS and EQ controls to the desired settings.
6.) When you are finished listening press the 
POWER button to return the unit to the Standby (Off) mode. The display lighting goes ‘Off’and the display changes from radio frequency to correct time.
16
PD3689_062005.p65 | 16 |
20/6/2005, 16:18