Roland AT20s Before You Start Playing, Setting Up the Music Stand, Connecting the Power Cord

Before You Start Playing

Opening/Closing the Lid	Turning the Power On and Off
fig.01-02	* Once the connections have been completed, turn on or off power
	to your various devices in the order specified. By turning on or
	off devices in the wrong order, you risk causing malfunction
	and/or damage to speakers and other devices.

1.To open the lid, hold it with both hands and slide it to the rear.

2.To close the lid, slowly pull it forward until it stops.

*Be careful not to get your fingers caught when opening or closing the lid. Adult supervision is recommended when small children are going to be using the instrument.

*To prevent accidents, be sure to close the lid before moving the organ.

*Make sure you don’t have anything (such as sheet music) on the keyboard when you close the lid.

Setting Up the Music Stand

fig.01-03

1.Attach the music stand by inserting it into the two holes.

Connecting the Power Cord

1.First, make sure that the [Power On] switch at the panel’s left side is OFF (not pushed in).

2.Connect the supplied power cord to the AC Inlet connector, then plug the other end into an AC

outlet.

fig.01-04

■Tuning On the Power

1.Make sure of the following before the power is turned on.

•Is the power cable correctly connected to the AC inlet?

•Is the power cable correctly connected to the AC outlet?

•Is the [Master Volume] knob (located at the left of the

Lower keyboard) set to the Min (minimum) position?

fig.01-05

Master

Volume

Min Max

2.Press the [Power On] switch to turn on the

power.

fig.01-06
Power On	Lower position
		ON

*This unit is equipped with a protection circuit. A brief interval (a few seconds) after power up is required before the unit will operate normally.

3.The [Master Volume] knob is an overall control for adjusting the volume of the entire instru- ment.

Position the Expression Pedal to the half-way mark. Now adjust the [Master Volume] knob to a suitable level. Now that this level has been set, you can use the Expression Pedal to change the volume with your foot as you play the AT-20S. The volume will be increased when the Expres- sion Pedal is pressed down, and decreased when the ped-

al is returned.

fig.01-07

decrease

Master the volume

Volume

*Only use the power cord supplied with this instrument.

*Whenever you do not intend to use the instrument for extended periods of time, pull out the power cord from the AC outlet.

Min Max

increase the volume

16