Roland AT20s owner manual To cancel the procedure, press the Display/Exit button

Using the Rhythm Performance

6. Press the Rhythm [Disk] button to confirm the storage-destination Rhythm.

fig.03-17

To cancel the procedure, press the [Display/Exit] button.

7. Press the Rhythm [Disk] button again to start loading the Rhythm into the internal memory.

While the Rhythm is being loaded into internal memory, the following screen will be dis- played.

fig.03-18

Once the Rhythm has been accommodated in memory, the basic screen reappears.

Never remove the disk or turn off the power while the Rhythm data is being

NOTE loaded from disk into the AT-20S. If you do so, the Rhythm data will not be loaded into the AT-20S, and malfunctions could result. After returning the Rhythm stored in the Rhythm [Disk] button to the factory settings (see following section), re-load the Rhythm from disk.

■Restoring the Rhythm Stored in the Rhythm [Disk] Button to the Factory Settings

The Rhythm that was loaded from the Music Style disk into the Rhythm [Disk] button will not disappear even if you turn off the power or execute the Factory Reset operation. If you wish to restore the Rhythm of the Rhythm [Disk] button to the factory setting, use the following procedure.

1. Press the [Power On] button to turn off the power (p. 17).

2. Hold down the Rhythm [Disk] button, and press the [Power On] switch.

The Rhythm that had been stored in the Rhythm [Disk] button will return to the factory settings.

To return settings other than those of the Rhythm [Disk] button to the factory settings, use the

Factory Reset operation (p. 18).

39