System connections
Make sure to unplug the AC power lead before making any connections.
Right |
|
|
speaker | Video cable | TV |
FM aerial |
|
(not supplied)
To video input socket
Left speaker
RED
BLACK
Wall socket
(AC 220 - 240 V ~ 50/60 Hz)
Label is located at the bottom of the unit.
■Aerial connection
Supplied FM aerial:
Connect the FM aerial wire to the FM 75 OHMS socket and position the FM aerial wire in the direction where the strongest signal can be received.
Note:
Placing the aerial on the unit or near the AC power lead may cause noise pickup. Place the aerial away from the unit for better reception.
■Speaker connection
●Connect the black wire to the minus
● Use speakers with an impedance |
|
of 4 ohms or more, as lower |
|
impedance speakers can damage |
|
the unit. | Incorrect |
● Do not mistake the right and the | |
left channels. The right speaker is |
|
the one on the right side when you |
|
face the unit. |
|
●Do not let the bare speaker wires touch each other.
●Do not allow any objects to fall into or to be placed in the bass reflex ducts.
●Do not stand or sit on the speakers. You may be injured.
■Demonstration mode
●The first time the unit is plugged in, the unit will enter the demonstration mode.
●To cancel the demonstration mode, press the DEMO/ DIMMER button (remote control) during power stand- by mode. The unit will enter the low power consumption mode.
●If iPod or iPhone is docked, the unit will begin charging. “Charge Mode” will displayed. Demonstration mode is invalid during charge mode.
●To return to the demonstration mode, press the DEMO/ DIMMER button again.
■Connecting iPod or iPhone to TV
Photo and video files from iPod or iPhone can be viewed by connecting the system to TV/monitor.
If the TV/monitor has a video input, connect it to the VIDEO OUT socket at the back of the unit and set the TV Out on the iPod or iPhone unit to “ON” position.
Note:
Please make sure to set iPod unit to either NTSC or PAL to match your TV signal. Please visit Apple’s homepage for further information.