Sharp XL-HF151PH(BK), XL-HF151PH(S) Timer and sleep operation Remote control only, Timer playback

Timer and sleep operation (Remote control only)

CD/USB

RDS

Timer playback:

The unit turns on and plays the desired source (CD, TUNER, USB, iPod, AUDIO IN, LINE IN) at a preset time.

This unit has 2 types of timer: ONCE TIMER and DAILY TIMER.

Once timer:

Once timer play works for one time only at a preset time.

(“” indicator). Daily timer:

Daily timer play works at the same preset time every day that we set. For example, set the timer as a wake-up call every morning.

(“DAILY” indicator).

Using the once timer and daily timer in combination: For example, use the once timer to listen a radio programme, and use the daily timer to wake up.

1Set the daily timer (pages 18 - 19).

2Set the once timer (pages 18 - 19).

1 minute or more

Daily timer Once timer

Start Stop Start Stop

■Timer playback

Before setting timer:

●Check that the clock is set to the correct time (refer to page 6). If it is not set, you cannot use the timer function.

●For timer playback: Plug in USB or load discs or dock iPod to be played.

1Press the ON/STAND-BY button to turn the power on.

2Press and hold the CLOCK/TIMER button.

3Within 10 seconds, press the or button to select “Once” or “Daily”, and press the ENTER button.

4Within 10 seconds, press the or button to select “Timer Set”, and press the ENTER button.

5To select the timer playback source (CD, TUNER, USB,

iPod, AUDIO IN, LINE IN), press the or button. Press the ENTER button.

When you select the tuner, select a station by pressing

the or button, and then press the ENTER button. If a station has not been programmed, “No Preset” will be displayed and timer setting will be cancelled.

6To adjust the day, press the or button and then press the ENTER button.

7Press the ENTER button to adjust the hour. Press the

or button and then press the ENTER button.

8To adjust the minutes, press the or button and then press the ENTER button.

9Set the time to finish as in steps 7 and 8 above.

10Adjust the volume using the VOLUME control, and then press the ENTER button. Do not turn the volume up too high.

11Press the ON/STAND-BY button to enter the power stand-by mode. The “TIMER” indicator lights up and the unit is ready for timer playback.

12 When the preset time is reached, playback will start. The volume will increase gradually until it reaches the preset volume. The timer indicator will blink during timer playback.

E-18