Repeated playback of songs in a catalogue

Repeated playback of songs in a catalogue

Press the MODE button during playback twice to repeatedly play all songs of the current cata- logue. ”REPT DIR” appears in the display.

Programmed playback

1.Press the STOP and then the EQ/PROG button.

2.Select the desired catalogue with the SKIP buttons (forwards/backwards).

3.Press the EQ/PROG button again.

4.Select the desired song in the desired catalogues with the SKIP buttons (forwards/backwards) and program it by pressing the EQ/PROG button again.

5.Repeat the steps described above to program the other songs. You may program up to 99 songs in any order.

6.When you have programmed all desired songs, start playback with the PLAY/PAUSE button.

After all programmed songs have been played, the player automatically changes into STOP mode. The songs you programmed remain in the memory until the CD compartment is opened or the player is switched off by pressing the STOP button again.

Searching for songs according to names

With MP3-conditions, you may search for songs by entering their names. You may only enter a maximum of 8 characters (letters or numbers). Before searching for songs, you should nd out whether the name of the artist or the song title was stored rst on the MP3 CD to identify the songs. Then either enter eight letters/numbers of the artist‘s name or eight letters of the song title.

1.Press the STOP button and keep the MODE button pressed until ”SONG SEARCH” appears in the display.

2.Select the initial of the song you are searching for with the SKIP buttons (forwards/backwards) when the letter A appears on the display. You may also enter numbers.

3.Press the MODE button to select the letter. Then a second letter is shown in the display. Proceed as described to select the second letter or second number. Press the STOP button to go back to the previous letter.

4.After you have entered the song title or artist‘s name, press the PLAY/PAUSE button and your input is compared with the names stored on the MP3 CD. If it nds the song, it is automatically played back. If it nds several songs, it plays the rst song it nds. If it does not nd it, the display shows ”NOT FOUND”.

Remote control

You may use the following functions of the player with the remote control supplied: PLAY/PAUSE, STOP, SKIP (forward/back), MODE, ALBUM/ESP/10+, EQ/PROG, HOLD, volume. Furthermore, you can connect the headphones up to remote control.