35
9Connecting the Archos™ 204 to a Stereo system
Connecting your Archos™ 204 to a stereo system allows you to listen to your Archos™ 204’s music on it without a headset. You will need a standard (mini headphone to RCA) audio cable for this which is not supplied with the Archos™ 204. The diagram below illustrates the setup. Plug the audio cable into the headphone jack and into the auxiliary jacks on your stereo. Note that this is only a schematic representation of a stereo. If in doubt, the manual of your stereo will enable you to identify the auxiliary inputs.
35
36
10 Connecting the Archos™ 204 to/from your Computer
10.1 USB Connection Type (‘Hard Drive’ or ‘Windows Device’)
Your device comes configured as a Windows® Device and will be immediately recognized by your computer if you are running Windows® XP (with Service Pack 1 minimum) and Windows Media® Player 10/11. If you have another version of Windows®, not sure what version of Windows® XP you have, or if you are using a Macintosh®, then you will need to change the USB (Universal Serial Bus) Port setting on the Archos™ 204. You will do this by going to System and USB Port and change it to ‘Hard Drive’.
10.2 Connecting the Archos™ 204
Connection order: See the sections below for your particular computer’s operating system.
1)Turn on the Archos™ 204.
2)With your computer running, plug the USB cable into your computer.
3)Plug in the other end of the USB cable to the Archos™ 204 USB Device port (if your computer asks to install a new driver for the new hardware, then you must unplug it and change the USB Port to Hard Drive.)
Windows® XP
Please verify* that you have Windows® XP and it is updated it to at least, Service Pack 1. You must also have Windows Media® Player 10 or 11 (WMP10/11) installed on your computer. This way, you can take advantage of connecting it as a ‘Windows Device’. Connect it to your PC as enumerated above and you can then see the Archos™ 204 in Windows® Explorer and WMP10/11. Without Windows® XP Service Pack 1 (a free update) or Windows Media® 10/11, you cannot use it as a Windows® recognized ‘Device’ and will have to follow the instructions for Windows® ME & 2000 below.
*
Windows™ ME and 2000
Attention: Before connecting the Archos™ 204 to your computer with the USB cable, go to Setup>System>USB Port and change it to ‘Hard Drive’.
36