Silvercrest SRD 250 A1 operating instructions Programming the wake time and method

Page 15

Handling and operation

Programming the wake time and method

When programming the alarm times, you can select whether, at the programmed time, alarm tones should sound or the radio should start playing. Two different alarm times (Alarm 1/Alarm 2) can be programmed.

Press and hold the AL1 button 16 or AL2 button 15. In the display 2 the hour indicator blinks.

Press or hold down the UP button 12 or DOWN button 10 to set the hour.

Press the AL1 button 16 or AL2 button 15 again. In the display 2 the minute indicator blinks.

Press or hold down the UP button 12 or DOWN button 10 to set the minutes.

Press the AL1 button 16 or AL2 button 15 again. The set wake time is accepted and in the display 2 appears the wake method indicator.

Press the UP button 12 to set the desired wake method ( =

Alarm tone or = Radio).

Press the AL1 button 16 or AL2 button 15 again to accept the setting.

NOTICE

If you want to be awakened with the radio, apart from the wake time programming you must also set, additionally, the desired radio station and volume (see section Radio operation).

GB

IE

SRD 250 A1

13

Image 15
Contents Clock Radio SRD 250 A1 R e w q 0 Operating components SafetyWarranty Service Importer Appendix Technical dataIntended use IntroductionInformation for these operating instructions CopyrightThese operating instructions the following warnings are used Appliance consumes power when in standby-mode SafetyInteraction with batteries Basic Safety InstructionsOnly permit children to use the appliance under supervision Operating components Setting up and connecting Package contents and transport inspectionSet-up location requirements Inserting the batteries Electrical connectionFor VHF reception completely unfold the wire antenna Providing mains powerVHF wire antenna Setting the timeRadio operation Programming the wake time and method Automatic Switch-off Sleep function Switching the alarm function onSwitching the alarm off Switching the alarm function offRisk of fatal electrocution CleaningSetting the display illumination Clean the surfaces of the device with a soft, dry clothMalfunction causes and remedies TroubleshootingDisposing of the batteries StorageDisposal Disposal of the applianceAppendix Technical dataInformation regarding the EG Conformity Declaration WarrantyService ImporterMail kompernass@lidl.ie