Sangean Electronics RCR-10 manual Manual tuning AM/FM

Page 16

Manual tuning – AM/FM

1. Press the Standby button to switch on your radio.

2.Press and release the Source button to select AM or FM radio mode.

3.Rotate the Tuning control to tune to a station. The FM frequency will

change in steps of 100kHz/50kHz and AM frequency will change in steps of 10kHz/9kHz.

2

4.When the end of the waveband is reached your radio will recommence tuning from the opposite end of the waveband.

5.Use the Volume control to adjust the sound level as required.

3

5

15

Image 16
Contents RCR-10 Page Table of contents Important Safety Instructions Page Introduction Controls LCD display Speaker Remote control sensor FM antenna Battery compartment Display icons Remote control Remote control functions Remote control battery replacementUsing the radio for the first time Using the AC power adaptorOperating your radio Search tuning AM/FM Manual tuning AM/FM Setting up the tuning step increment Display modes FM FM range setting FM stereo auto / monoPresetting stations in AM/FM mode Recalling a preset in AM/FM modeDocking you iPod by dock adjuster IPod dockingCharging your iPod Navigating your iPod Playing an audio file on your iPodSearch function Your RCR-10 works with the following models of iPodClock and Alarms Setting the time formatSetting the clock time Radio-controlled clockManual setting Radio Data System RDS Setting the alarm clock When the alarm sounds Disabling / cancelling alarms SnoozeSleep timer Time zone setting Daylight Saving Time Display & Audio setup Dimmer controlLoudness Auxiliary input socket Headphone socketLine out socket Software versionSpecifications Circuit Features Frequency Range