Sangean Electronics RCR-10 Presetting stations in AM/FM mode, Recalling a preset in AM/FM mode

Page 20

Presetting stations in AM/FM mode

There are 5 preset stations each for AM and FM radio. They are used in the same way for each waveband.

1.Press the Standby button to switch on your radio.

2.Press the Source button to select the desired waveband. Tune to the required radio station as previously described.

3.Press and hold the required Preset button (1 to 5) until the display shows “P4” for example after the frequency. The station will be stored using the preset number. Repeat this procedure for the remaining presets as you wish.

4.Preset stations which have already been stored may be overwritten by following the above procedure if required.

Recalling a preset in AM/FM mode

1.Press the Standby button to switch on your radio.

2.Select the required waveband by pressing the Source button.

3.Momentarily press the required Preset button to cause your radio to tune to one of the stations stored in the preset memory.

Note:

the remote control can only recall preset stations. Presetting stations can’t be operated by remote control.

2

3

19

Image 20

Contents RCR-10 Page Table of contents Important Safety Instructions Page Introduction Controls LCD display Speaker Remote control sensor FM antenna Battery compartment Display icons Remote control Remote control functions Remote control battery replacementUsing the radio for the first time Using the AC power adaptorOperating your radio Search tuning AM/FM Manual tuning AM/FM Setting up the tuning step increment Display modes FM FM range setting FM stereo auto / monoPresetting stations in AM/FM mode Recalling a preset in AM/FM modeDocking you iPod by dock adjuster IPod dockingCharging your iPod Navigating your iPod Playing an audio file on your iPodSearch function Your RCR-10 works with the following models of iPodClock and Alarms Setting the time formatSetting the clock time Radio-controlled clockManual setting Radio Data System RDS Setting the alarm clock When the alarm sounds Disabling / cancelling alarms SnoozeSleep timer Time zone setting Daylight Saving Time Display & Audio setup Dimmer controlLoudness Auxiliary input socket Headphone socketLine out socket Software versionSpecifications Circuit Features Frequency Range