JBL SCS180.6 manual Read First, Important Safety Precautions

Page 2

READ FIRST!

Important Safety Precautions!

1.Read these instructions.

2.Keep these instructions.

3.Heed all warnings.

4.Follow all instructions.

5.Do not use this apparatus near water.

6.Clean only with a dry cloth.

7.Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.

8.Do not install near any heat sources such as radiators, heat registers, stoves or other apparatus (including amplifiers) that produce heat.

9.Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other. A grounding- type plug has two blades and a third grounding prong. The wide blade or the third prong are provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet.

10.Protect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles and the point where they exit from the apparatus.

11.Only use attachments/accessories specified by the manufacturer.

12.Use only with the cart, stand, tri- pod, bracket or table specified by the manufacturer or sold with the appara- tus. When a cart is used, use caution when moving the cart/appa-

ratus combination to avoid injury from tip-over.

13.Unplug this apparatus during light- ning storms or when unused for long periods of time.

14.Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.

15.Do not use attachments not recommended by the product manufacturer, as they may cause hazards.

16.This product should be operated only from the type of power source indicated on the marking label. If you are not sure of the type of power sup- ply to your home, consult your product dealer or local power company. For products intended to operate from bat- tery power, or other sources, refer to the operating instructions.

17.If an outside antenna or cable system is connected to the product, be sure the antenna or cable system is grounded so as to provide some protection against voltage surges and built-up static charges. Article 810 of the National Electrical Code, ANSI/ NFPA 70, provides information with regard to proper grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna dis- charge unit, size of grounding conduc- tors, location of antenna-discharge unit, connection to grounding elec- trodes, and requirements for the grounding electrode. See Figure A.

18.An outside antenna system should not be located in the vicinity of over- head power lines or other electric light or power circuits, or where it can fall

Figure A.

Example of Antenna Grounding as

per National Electrical Code

ANSI/NFPA 70

into such power lines or circuits. When installing an outside antenna system, extreme care should be taken to keep from touching such power lines or circuits, as contact with them might be fatal.

19.Do not overload wall outlets, extension cords, or integral convenience receptacles, as this can result in a risk of fire or electric shock.

20.Never push objects of any kind into this product through openings, as they may touch dangerous voltage points or short-out parts that could result in a fire or electric shock. Never spill liquid of any kind on the product.

21.The apparatus shall not be exposed to dripping or splashing, and no objects filled with liquids, such as vases, shall be placed on the apparatus.

22.Do not attempt to service this product yourself, as opening or removing covers may expose you to dangerous voltage or other hazards. Refer all servicing to qualified service personnel.

23.When replacement parts are required, be sure the service tech- nician has used replacement parts specified by the manufacturer or that have the same characteristics as the original part. Unauthorized substitu- tions may result in fire, electric shock or other hazards.

24.Upon completion of any service or repairs to this product, ask the service technician to perform safety checks to determine that the product is in proper operating condition.

25.The product should be mounted to a wall or ceiling only as recommended by the manufacturer.

2

Image 2
Contents OWNER’S Guide Important Safety Precautions Read FirstJBL Consumer Products Thank YOU for Choosing JBLIncluded Speaker Placement Front Center Channel Speakers Subwoofer Surround SpeakersWALL-MOUNTING Mounting OptionsSatellites and Surrounds Mounting the Satellites on Optional FS1000 Floor StandsSpeaker Connections Connection TipsDolby PRO Logic NON-DIGITAL Line Level Dolby PRO Logic NON-DIGITAL Speaker Level Speaker LevelOperation When the Auto/On switchVolume Turn off all electronics TroubleshootingReview proper operation of your receiver/amplifier If there is no sound from the surround speakers Specifications PRO Sound Comes Home