JBL SCS180.6 manual Mounting Options, Satellites and Surrounds, Wall-Mounting

On optional stands (FS1000).

Attach plate to wall. The brackets should be placed, if possible, so that the screws will fasten into a wooden wall stud. If that is not possible, use properly selected wall anchors.

The customer is responsible for proper selection and use of mounting hardware, avail- able through hardware stores, to properly and safely wall-mount the speakers.

Slide speaker onto support.

IMPORTANT NOTE: The satellite speaker, when mounted on these brackets, can only be adjusted hori- zontally (left or right). The speaker cannot be adjusted vertically (up or down) or otherwise tilted. Any attempt to do so will damage the speaker bracket wall plate and/or support and such damage will not be covered under warranty.

Place speaker and support on wall plate. Make sure that at least 1/4" (6mm) of the wall plate metal shaft is inserted into the support cavity. Continue to firmly press the support onto the wall plate metal shaft until it is fully secured in place.

3.

2.

1.

1.Attach the stand adaptor to the top of the stand upright with the pins toward the rear of the stand. Fasten the adaptor to the upright with the supplied screw.

2.Place the loudspeaker securely on the stand by

inserting the adaptor pin into the grommet on the bottom of the speaker.

3.Connect the wire to the loudspeaker, remember- ing to preserve the polarity (“+” and “–”) (see page 6).