Push the MENU/NAVI handle toward 
or 
, or push the REC button on the remote control toward BITRATE to select BITRATE TYPE to set recording quality. This is only for MP3 file.
When saving as WAV file, the Bitrate generally is 1411Kbps. (44.1 KHz, 16Bit, Stereo)
When saving the optical signal with 48KHz as WAV file, the Bitrate is 1536Kbps. (48 KHz, 16Bit, Stereo)
Push the REC button to start recording.
When recording from an external audio device, be sure to start the playback on that device when recording on to the iHP.
NOTE Volume level can not be controlled on the iHP while recording from an external device.
While recording, press 
(STOP/PWR OFF) to stop recording and switch to recording standby mode. Press the REC button again to begin recording to a new file.
Press the REC button to pause recording. And press the REC button again to restart recording.
TO PAUSE RECORDING
During recording, press REC button to pause recording, press REC button again to start recording.
TO STOP RECORDING
At recording standby mode, press and hold 
button to go previous mode.
Recorded files are stored in folders matching the source name from where the audio was recorded.
-Line In/Optical In : ROOT\RECORD\AUDIO\AUDIOXXX.MP3(WAV)
-INT/EXT Mic : ROOT\RECORD\VOICE\VOICEXXX.MP3(WAV)
Recording is automatically stopped if:
-The iHP's memory is full.
-When the recorded MP3 file size is over 195MB
-When the recorded WAV file size is over 795MB
-The recorded time is longer than 5 hours.
-The battery is low.
-When sampling rate is changed during optical recording
Caution
Optical recording can sample at 44.1KHz or 48KHz. It is important to match the recording sampling rate with the playback sampling rate of your optical output device. Note, when the player is is Record Standby Mode, it will automatically shut off according to the "STOP POWER OFF" setting (Refer to page 43).
TO PLAY THE RECORDED FILE
Press |
|
|
| button to play the recorded file at the |
|
| |||
|
|
recording standby mode.
34 | 35 |