5. | If the front and rear outputs have been set to high pass by setting the |
| switch on the rear panel to the high pass setting, adjust the front |
| crossover to the lowest possible setting with a minimum of distortion. |
| Repeat for the rear speakers. |
6. | At this time adjust the subwoofer frequency and volume to match the |
| crossover settings for the satellite speakers. When set properly the bass |
| should not be localized and voices should not be heard through the |
| subwoofers. |
7. | Adjusting the frequency control knobs out direction from center will |
| change the center frequency and bandwidth parameter for that |
| particular filter. The higher the frequency (clockwise) for a filter the wider |
| bandwidth, the lower the frequency |
| bandwidth. |
8. Once the center frequencies and bandwidth have been adjusted controls have been set, use the filter gains (filter knob’s in position) to fine tune the system for differing tastes in music or material.
SYSTEM DIAGRAM
ATC 3A |
GROUND
REMOTE IN (+)12V CONSTANT REMOTE OUT
To Rear Amp
To Front Amp
To Sub Amp
To Source 2
To Source 1
8