Toshiba user manual Setup SD-C2502, Installation Notes, Software Driver

SETUP – SD-C2502

Toshiba recommends that only trained professionals install this DVD-ROM drive into your laptop/notebook.

Installation Notes

•The SD-C2502 DVD-ROM drive has no jumpers that need to be set

•Mounting orientation: 15° (horizontally), 15° vertically (volume control in down position), 30° (drive with volume control in up position).

•When mounting drive use 4 M2-PO.4 tapping holes located on the left and right sides of drive.

•When mounting drive, the tightening torque of the four screws must be even. Recommended screw tightening torque is 2Nm

•For clearance around the front bezel, it is recommended that a clearance of more than 0.8mm should be left in all directions.

Software Driver

Toshiba's SD-C2502 drive does not require any unique device drivers for Windows '98/2000/XP/NT. After installing your drive and re-booting, your system should recognize your drive. Win '98/2000/XP/NT Operating Systems support all Toshiba's ATAPI drives natively. If you prefer using DOS, download the ATAPI driver from our web site.

3