Introduction | General Information |
English
Thank you for purchasing this Philips DVD/ VCR.This Owner’s Manual explains the basic operation of this DVD/ VCR.
Environmental Information
All unnecessary packaging has been omitted.
Packaging has been made easy to separate into three materials: cardboard (box), polystyrene foam (buffer) and polyethylene (bags, protective foam sheet).
Your DVD/VCR consists of materials which can be recycled and reused if disassembled by a specialised company. Please observe the local regulations regarding the disposal of packaging materials, exhausted batteries and old equipment.
Supplied Accessories
• Remote control • Batteries (two AA size) for Remote control
• SCART cable • RF Coaxial cable • Owner’s Manual
Safety Information
•To reduce the risk of fire or electric shock, do not expose this device to rain or moisture.
•Before operating the DVD/VCR, check that the operating voltage indicated on the typeplate (or the voltage indication beside the voltage selector) is identical with the voltage of your local power supply. If not, please consult your dealer.
•Place the DVD/VCR on a flat, hard and stable surface.
•There must be sufficient room in front of the player for the disc tray to be opened.
•In cabinet, allow about 2.5cm (1inch) of free space all around the player for adequate ventilation.
•Do not expose your player to extreme of temperature or humidity.
•If the DVD/VCR is brought directly from a cold to a warm location, or is placed in a very damp room, moisture may condense on the lens of the disc unit inside the DVD/VCR player. Should this occur, the DVD/VCR would not operate normally. Leave the player on for about one hour with no disc in the DVD/VCR until normal playback is possible.
•The mechanical parts of the set contain
•Never spill liquid of any kind on this unit. If liquid is spilled into the unit, consult qualified service engineer.
•When the DVD/VCR is switched to Standby mode, it is still consuming some power. To disconnect the system from the power supply completely, remove the AC power plug from the wall socket.
TM
SHOWVIEW is a trademark of Gemstar Development Corporation.
The SHOWVIEW system is manufactured under licence from Gemstar Development Corporation.
The region code for this set is 2.
Since it is usual for DVD movies to be released at different times in different regions of the
world, all players have region codes and discs2 can have an optional region code. If you load a
disc of a different region code to your player, you will see the region code notice on the
screen. The disc will not playback, and should be unloaded.
Manufactured under license from Dolby Laboratories. “Dolby” and the
This product incorporates copyright protection technology that is protected by method claims of certain U.S. patents and other intellectual property rights owned by Macrovision Corporation and other rights owners. Use of this copyright protection technology must be authorised by Macrovision Corporation, and is intended for home and other limited viewing uses only unless otherwise authorised by Macrovision Corporation. Reverse engineering or disassembly is prohibited.
The DVD/ VCR is in conformity with the EMC directive and
For Customer Use:
So that you can identify your machine for service questions or in the event of theft, enter the serial number here.The serial number (PROD. NO.) is printed on the type plate fixed at the back of the device.
Model No. DVP620VR
Serial No. ________________________________________
This product complies with the requirements of Directive 73/23/EEC +89/336/EEC +93/68/EEC.
Laser safety
This unit employs a laser. Due to possible eye injury, only a qualified service person should remove the cover or attempt to service this device.
USE OF CONTROLS OR ADJUSTMENTS OR OF PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN MAY RESULT IN HAZARDOUS RADIATION EXPOSURE.
LASER |
|
Type | Semiconductor laser GaAlAs |
Wave length | 655 nm (DVD) |
| 790 nm (VCD/CD) |
Output Power | 0.8 mW (DVD) |
| 0.5 mW (VCD/CD) |
|
|
CLASS 1 LASER PRODUCT | (WARNING | |
LOCATION: | ||
KLASSE 1 LASER PRODUKT | ||
ON THE BACK- | ||
KLASS 1 LASER APPARAT | ||
PLATE OF SET) | ||
CLASSE 1 PRODUIT LASER |
About the PBC Function of Video CD
•This unit conforms to ver.1.1 and ver.2.0 of VIDEO CD standard, with PBC function.
Ver.1.1 (without PBC function):You can enjoy playback picture
as well as music CD.
Ver.2.0 (with PBC function):When using a VIDEO CD with PBC function,“PBC” appears on the display.
•“PBC” stands for Play Back Control.
•Video CD with PBC function has its original menu. Menu operation may vary depending on the disc. Refer to the manual included in the disc for details.
•“PBC” appears on the front panel display when a Video CD with PBC function is loaded.
2