Power Supply
Power supply
Whenever convenient, use the power cord if you want to conserve battery life. Make sure you remove the plug from the set and wall outlet before inserting batteries.
Batteries (not included)
Main set (see 2)
•Insert 6 batteries, type
•Incorrect use of batteries can cause electrolyte leakage and will corrode the compartment or cause the batteries to burst:
•Do not mix battery types: e.g. alkaline with carbon zinc. Only use batteries of the same type for the set.
•When inserting new batteries, do not try to mix old batteries with the new ones.
•Remove the batteries if the set is not to be used for a long time.
Batteries contain chemical substances, so they should be disposed of properly.
Using AC Mains
1Check if the mains voltage, as shown on the type plate located on the bottom of the set, corresponds to your local mains supply. If it does not, consult your dealer or service center.
2Connect the mains lead to the AC MAINS ~ inlet and the wall socket. The mains lead is now connected and ready for use.
3To switch the set off completely, withdraw the mains lead from the wall socket.
4Install the unit near the AC outlet and where the AC power plug can be easily reached.
•Disconnect the mains lead from the wall socket to protect your set during heavy thunderstorms.
All markings are located on the bottom of the set.
Helpful hints:
–To avoid unnecessary energy consumption, always adjust the Source selector to TAPE/OFF after using the set. Also check that the tape deck keys are released.
CAUTION
-Visible and invisible laser radiation. If the cover is open, do not look at the beam.
-High voltage! Do not open.You run the risk of getting an electric shock.The machine does not contain any
-Modification of the product could result in hazardous radiation of EMC or other unsafe operation.