English
TROUBLESHOOTING
If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or service centre.
WARNING: Do not open the set as there is a risk of electric shock. Under no circumstances should you try to repair the set yourself, as this will invalidate the guarantee.
Problem | Solution |
CD/VCD OPERATION |
|
"NO DISC" is displayed | – Insert a disc. |
| – Check if the disc is inserted upside down. |
| – Wait until the moisture condensation at the lens has |
| cleared. |
| – Replace or clean the disc, see "Maintenance" |
| – Use a readable disc or correct recorded format |
|
|
No picture on TV screen | – Connect the cable between the system and TV. |
No colour on TV | – Change the system to the respective PAL or |
| NTSC setting. |
|
|
RADIO RECEPTION |
|
Radio reception is poor | – If the signal is too weak, adjust the antenna |
| for better reception. |
| – Increase the distance between the Receiver |
| and your TV or VCR. |
|
|
TAPE OPERATION/RECORDING |
|
Recording or playback cannot be made | – Clean deck parts, see "Maintenance". |
| – Use only NORMAL (IEC I) tape. |
| – Apply a piece of adhesive tape over the missing |
| tab space. |
|
|
GENERAL |
|
The system does not react when buttons | – Slide the source sector to TAPE/OFF. Remove and |
pressed/set does not work/no display on | reconnect the AC power plug for 30 seconds and |
LCD. | switch on the system again. |
Sound cannot be heard or is of poor | – Adjust the volume. |
quality | – Make sure the |
| |
| frequencies at 8 - 48 kHz (44.1kHz preferably). |
The remote control does not function | – Reduce the distance between the remote control |
properly | and the system. |
| – Insert the batteries with their polarities (+/- signs) |
| aligned as indicated. |
| – Replace the batteries. |
| – Point the remote control in the direction of the |
| system's IR sensor. |
|
|
20