Haier AS102ALARA Installation Name of Parts, Indoor Unit Wiring for Indoor and Outdoor Units

Page 5

Installation

Name of Parts

Indoor Unit:

Wiring for Indoor and Outdoor Units

1. Wiring Method for Ring Terminal

The wiring method is as the drawing below for the ring terminal: Remove the connection screw and put the screw through the ring on the connection wire terminal, then connect it to the terminal blocks, then screw it tightly.

2.Wiring Method for Line Terminal

The wiring method is as follows for the non-ring terminal:

Loosen the connection screw and insert the connection wire end into the terminal block completely, screw it tightly, then slightly pull out the connection wire to ensure it be clamped tightly.

3. Method for Pressing the Connection Wire

After wiring, the connection wire must be pressed tightly with a wire- pressing clip, which should press the outer sleeves of the wire as the right drawing:

Correct Pressing

Wiring Method for

Ring Terminal Block

Wrong Pressing

Terminal

block

Pressing

Clamps

1.Inlet Grill

2.Anion Generator (inside)

3.Air Filter

4.Swing louver

It can be adjusted to upward or downward with the remote controller only (Do not adjust it manually)

5.Power or Healthy Operation Indicator

After the air conditioner is started, this indicator lights up; when the healthy operation is started,this indicator turns green.

6.Timer Set Indicator

When the air conditioner is at the state of time-set, this indicator lights up.

7.Test Manual Button

 

This button is only used for test refrigerating operation when the room temperature is below 16 , so it

 

should not be used in normal situation.

 

8.

Emergency Manual Button

 

 

When the remote controller is lost or cannot be used, this button can make the air conditioner continue

 

to operate for the time being.

 

9.

Remote Signal Receiving Window

 

 

It receives the remote signal from the remote controller.

 

10.

Working Method Indicator

 

 

When the compressor is working, the indicator lights up .

11

11. Power Plug

 

 

1

 

 

 

7

Wiring for Indoor Unit and Outdoor Unit

Lay out the connection wires as the connection drawing (Notes: The two ends of the connection wires are different, never connect reversely)

1)Open the wire cover, unscrew the pressing clamp(outdoor unit).

2)Connect the connection wires as per the wiring method and the wiring drawing (the wires on the indoor unit shall be inserted from behind as the attached drawing).

3)Ensure that the terminals are clamped tightly, and press the connection wires(outdoor unit) as per the pressing method, then install the wire-pressing cover.

Air Inlet Grille

 

Pressing Cover

Terminals

 

Pressing Clamp

Screw

Power Supply Wire

 

Indoor and Outdoor

 

Connection Wires

Notes:

When connecting the wires of indoor and outdoor units, check the numbers on the terminals of the indoor and outdoor units,the same wire shall connect the same number and color terminal

Wrong connection would damage the air conditioner,s controller,or the unit cannot work.

Outdoor Unit:

 

 

 

 

 

 

1.

Inlet

 

 

 

 

 

8

 

 

 

 

 

 

 

2.

Outlet

3

 

 

 

 

 

 

Send out hot air when cooling,

 

 

 

 

 

 

 

and send out cold air when heating .

 

 

 

 

 

 

3.

Inlet

2

4

5

6

10

9

4.Connection pipe and electric wiring.

5.Drain Hose

3

1

4

2

5

30

3

Image 5
Contents Split AIR Conditioner Contents Disposal of the packaging of your new air conditioner Safety Instructions and WarningsDisposal of the old air conditioner Specifications Installation Check and Trial OperationOutdoor Unit Installation Name of PartsIndoor Unit Wiring for Indoor and Outdoor Units Piping Connection for Outdoor Unit InstallationRemote Controller Drain Elbow Drain Hose Installation Operation HintsPiping Protective Cover Installation of Indoor Unit Operation Hints InstallationCold Air Prevention DefrostOperation Refrigeration Oil Connector Nut SpannerCutting hose Removing burr Put on nut Expand HoseBrief Introduction to Health Operation Cancel Healthy OperationSet Healthy Operation Electrical Requirements Select Temperature Setting Press Temp. buttonTurn on the Air Conditioner Hose SelectionLeft and Right Adjustmentmanual Adjustment of Air Flow DirectionInstallation Tools Self-contained AccessoriesTimer Setting Installation Drawing for Indoor and Outdoor UnitsTime Setting Time Set OperationTrouble Shooting Trouble Shooting Operation Followings are not malfunction HuaMaintenance before Season of Use MaintenanceMaintenance after Season of Use Clean the Air Conditioner Installation and Replacement of Air FilterDust Filter Air Filter

AS102ALARA, AS122AYARA, AU122ACARA, AS122AVARA, AS102AMARA specifications

The Haier AU102ACARA, AS102AMARA, AS122AVARA, AU122ACARA, and AS122AYARA air conditioning units exemplify innovative design and advanced technology aimed at providing optimum comfort in various environments. These models are suited for both residential and commercial applications, showcasing efficiency and quiet operation, essential for any space.

One of the key features of these Haier models is their energy efficiency. Each unit is designed with advanced inverter technology that adjusts the compressor speed seamlessly to maintain the desired temperature. This not only provides better cooling performance but also leads to significant energy savings, making it an environmentally friendly choice.

The units are equipped with smart capabilities, enabling users to control their air conditioning systems through mobile apps. This allows for greater flexibility and convenience, as users can adjust their settings from anywhere, ensuring their environment is always comfortable upon arrival.

In addition to smart controls, these models feature a sleek, modern design that blends easily with any decor. The compact form factor is particularly appealing for urban living spaces where every square foot counts. Moreover, these air conditioners are equipped with high-density filters that provide exceptional air purification, capturing dust, allergens, and pollutants to improve indoor air quality.

The Haier AU102ACARA and AS102AMARA are particularly noted for their compact size and efficiency, making them ideal for smaller rooms. The AU122ACARA and AS122AYARA, on the other hand, offer increased cooling capacities, suitable for larger spaces while maintaining the same high efficiency standards.

Noise levels are another consideration with the Haier models, which operate at whisper-quiet levels, ensuring that indoor tranquility is preserved. This feature is crucial for bedrooms or study areas where distractions should be kept to a minimum.

In summary, the Haier AU102ACARA, AS102AMARA, AS122AVARA, AU122ACARA, and AS122AYARA air conditioning units combine energy efficiency, smart technology, modern aesthetics, effective air filtration, and low noise operation, making them excellent choices for anyone looking to enhance their indoor comfort. With their various capacities and features, these models cater to a wide range of needs, ensuring a pleasant environment throughout the year.