Note
•Before pressing any function button on the remote control, fi rst select the correct source with the remote control instead of the main unit.
•If you are not going to use the remote control for a long time, remove the battery.
Auto install radio stations
When you connect power and no radio stations are stored, the DCM250 automatically begins to store radio stations.
1Connect the DCM250 to the power supply.
»[AUTO INSTALL - PRESS PLAY] (auto install - press the PLAY button) is displayed.
2Press 
on the main unit to start installation.
»The DCM250 automatically stores radio stations with suffi cient signal strength.
»When all the available radio stations are stored, the fi rst preset radio station is broadcast automatically.
Set clock
1In standby mode, press PROG to activate the clock setting mode.
»The 12 hour or 24 hour format is displayed.
2Press 
/ 
to select 12 hour or 24 hour format.
3Press PROG.
»The hour digits are displayed and begin to blink.
4Press 
/ 
to set the hour.
5Press PROG.
»The minute digits are displayed and begin to blink.
6Press 
/ 
to set the minute.
7Press PROG to confi rm.
Turn on
1Press 
.
»The DCM250 switches to the last selected source.
Switch to standby
1Press 
to switch the DCM250 to standby mode.
»The backlight on the display panel is reduced.
»The clock (if set) appears on the display panel.
To switch the DCM250 to Eco Power Standby mode:
1In standby mode, press and hold 
for more than 2 seconds.
»The backlight on the display panel turns off.
English
EN 15