Get started, Install remote control battery

3 Get started

Always follow the instructions in this chapter in sequence.

Caution

•Risk of explosion! Keep batteries away from heat, sunshine or re. Never discard batteries in re.

•Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type.

•The battery contains chemical substances, so it should be disposed of properly.

•Keep children away from the battery.

•Perchlorate Material - special handling may apply. See www.dtsc.ca.gov/hazardouswaste/ perchlorate.

For rst-time use:

Remove the protective tab to activate the battery.

To replace the battery: C

Caution

•Risk of product damage! Ensure that the power voltage corresponds to the voltage printed on the back or underside of the clock radio.

•Risk of electric shock! When you unplug the AC adapter, always pull the plug from the socket. Never pull the cord.

Warning

•To reduce the risk of re or electric shock, do not expose this clock radio to rain or moisture.

1In standby mode, press and hold SET TIME for two seconds to activate clock setting mode.

»The hour and minute digits begin to blink.

2Press / and / repeatedly to set the hour and minute.

3Press SET TIME to con rm.

» [12H] or [24H] begins to blink.

4Repeat Steps 2-3 to select 12/24 hour format.

» The set time is displayed.

Note

•When iPod/iPhone is connected, the clock radio synchronizes time from the iPod/iPhone automatically.

Press .

»The clock radio switches to the last selected source.

•To select a source, press SOURCE repeatedly or the source selection buttons on the remote control.

Press again to switch the clock radio to standby mode.

»The clock (if set) appears on the display panel.

6EN