Collect settings of your home Wi-Fi router

Collect settings of your home Wi-Fi router

Note

•• Always consult the user manual of your home Wi-Fi router for detailed instructions.

1Connect your Wi-Fi enabled device to your existing home Wi-Fi network.

2Launch the Internet browser (for example,

Apple Safari or Microsoft Internet Explorer) on your Wi-Fi enabled device.

3Open the configuration page of your home Wi-Fi router.

4Find the Wi-Fi settings tab and write down the following information on paper:

A Network name (SSID)

B Wi-Fi security mode (usually WEP,

WPA or WPA2 if enabled)

C Wi-Fi password (if Wi-Fi security is enabled)

D DHCP mode (enabled or disabled)

E Static IP address settings (if DHCP mode is disabled)

Switch AD7000W to Assisted Wi-Fi Setup mode

Note

•• Before you press any button on AD7000W, make sure that AD7000W has been booted up successfully.

10EN

•Press and hold Wi-Fi SETUP on the back of AD7000W for more than 5 seconds.

»»The Wi-Fi SETUP indicator blinks green and yellow alternately.

»»A new Wi-Fi network created by

AD7000W will appear, with the network name (SSID) of Philips Fidelio AirPlay.

»»It may take up to 45 seconds for successful creation of this new Wi-Fi network.

Note

•• After you finish manual Wi-Fi setup for AD7000W, the new Wi-Fi network created by AD7000W will disappear.

•• If you fail to enter Assisted Wi-Fi Setup mode, power off AD7000W and power on it, then try again after successful boot-up.

•• Make sure that there are no other Philips AirPlay- enabled devices in Assisted Wi-Fi Setup mode at the same time. Multiple Wi-Fi networks created this way may interfere with each other.