For series 242, Open inlet grill, Clean

(For series 242, 282 )

[Clean air filter]		(B) Wash with water.
[Clean air filter]		With too much dust, use soft brush and neutral
NOTE	When having to clean, don't dismantle	With too much dust, use soft brush and neutral
NOTE	When having to clean, don't dismantle	detergent.
	air-filter,otherwise may cause faults.	detergent.
	air-filter,otherwise may cause faults.	Swing off the water, and then place in cool place.
	In the environment where there is too	Swing off the water, and then place in cool place.
	In the environment where there is too
	much dust, air filter should be cleaned
	for more times.
	(about half a year one time)

Press the elliptical "PUSH" knob, the inlet grill will automatically drop. (the inlet grill is catched with two pothooks)

5. Install air filter
(1)	Put filter into protruding parts at the top of
	the inlet grill.
(2)	Connect the two pothooks with inlet grill

PUSH

Press the elliptical knob the inlet grill will automatically drop

See 2

Open two	Pothook
pothooks

Connet the two pothooks with inlet grill

6.Close inlet grill See 1.

7.Press the filter signal return key on the

controller. '' ''

Air filter

Drag the knob of the grill back lift the filter and take down.

CAUTION!

1. Open inlet grill

Press the elliptical "PUSH" knob, the inlet grill will automatically drop. (the inlet grill is catched with two pothooks)

PUSH

Press the elliptical knob the inlet grill will automatically drop

(A) Remove dust with vacuum filter.

Open two	Pothook
pothooks