English
Installing Unit into A Window
Window Opening Requirements
The | air conditioner is designed to fit into double or single hung sash | type w | |||||
units comes | with an installation kit that provides adjustable mounting louvers | ||||||
between the | sides of | the unit, and the window | frame. The | chart | below | reflects | |
the | units with, and | without installation kits. | Measure | your | window | opening | |
it to the chart below to ensure that it meets the minimum and maximum window width require
B
A
C
D
HWR10XC5, HWR12XC5,ESA3105, ESA3125
Model | HWR10XC5, HWR12XC5, ESA3105, ESA3125 | |||||||
Dimension | ||||||||
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
| |
A(inch) | 8 3221 | " | ||||||
B(inch) | 15 | 9 | " | |||||
16 | ||||||||
C(inch) | 15 1516 " | |||||||
D(inch) Max | 39 | " | ||||||
D(inch) Min | 27 | " | ||||||
Case High | 14 |
| 31 |
| " | |||
32 |
| |||||||
Case Width | 23 | 5 |
| " | ||||
8 |
| |||||||
Case Depth | 22 | 7 |
| " | ||||
16 |
| |||||||
|
|
|
|
|
|
|
| |
e d o M
1 PREPAREFOR UNIT INSTALLATION-1
Unpack unit on floor next to installation location. |
|
1. Open the inlet grille by pulling the exposed door on |
|
the top of the unit and remove the screw which fasten the |
|
front panel. (Fig. A) |
|
2. Remove the front panel and rotate it to B position. |
|
Separate operation panel from the front panel by pushing | Fig. A |
the tabs. (Fig. B) |
Tabs