Sony MDS-JE500 Changing an existing title Z, Erasing all titles on a disc Name Erase Function

Changing an existing title Z

1Press NAME, then do the following:

To change	Make sure that the deck is
A track title	Playing, pausing the track whose title
	is to be changed, or stopped after
	locating the track whose title is to be
	changed
A disc name	Stopped with no track number
	appearing in the display

2Keep pressing CLEAR (or EDIT/NO on the deck) until the current title is erased.

3Enter the new title.

Do Steps 3 to 6 of “Labeling Recordings” on page 26, or Steps 2 to 4 of “Labeling tracks and MDs with the remote” on page 28.

4Press NAME.

Erasing all titles on a disc (Name Erase Function)

Use this function to erase all titles on an MD simultaneously.

Note that once erased, titles cannot be recovered.

1Press EDIT/NO repeatedly while the deck is stopped until “All Erase ?” appears in the display.

2Press EDIT/NO again.

“Name Erase ?” appears in the display.

3Press YES.

All titles are erased.

To cancel the Name Erase Function

Press p.

You can erase all recorded tracks and titles

See “Erasing all tracks on an MD” on page 23.

Editing Recorded MDs

Undoing the Last Edit (Undo Function)

You can use the Undo Function to cancel the last edit and restore the contents of the MD to the condition that existed before editing was done. Note, however, that you cannot undo an edit if you do any of the following after the edit:

•Press the r REC button on the front panel.

•Press the r button, the MUSIC SYNC button, or the CD-SYNC STANDBY button on the remote.

•Update the TOC by turning off the power or ejecting the MD.

•Disconnect the AC power cord.

- ±

	•	•
	•	•
	•	•
	•	•
0 )	•	•
	0	10

¤EJECT

	á	P	p	r
				REC
EDIT/NO	YES

1With the deck stopped and no track number appearing in the display, press EDIT/NO repeatedly until “Undo ?” appears in the display. “Undo ?” does not appear if no editing has been done.

2Press YES.

One of the following messages appears in the display, depending on the type of editing to be undone:

Editing done:	Message:
Erasing a single track	“Erase Undo ?”
Erasing all tracks on an MD
Dividing a track	“Divide Undo ?”
Combining tracks	“Combine Undo ?”
Moving a track	“Move Undo ?”
Labeling a track or an MD
	“Name Undo ?”
Changing an existing title
Erasing all titles on an MD

3Press YES again.

“Complete” appears for a few seconds and the contents of the MD are restored to the condition that existed before the edit.

To cancel the Undo Function

Press EDIT/NO or p.

29