OPERATING INSTRUCTIONS
•Make sure that you have either installed the 8 “C” batteries or have connected the unit to your household AC outlet.
•Make sure that you have removed the clear plastic battery spacer tab from the remote control.
Setting The Clock
NOTE: The clock can only be set while the system is in the power ‘Off’mode. If the power is ‘On’press the Power button on the main cabinet or remote control to shut the power ‘Off’, the proceed to set the clock as follows:
1.) Press the Time/Display button once. The display lighting turns on and the Hour digits begin to flash.
2.) While the Hour digits are flashing
press the () or () buttons to move the display forward or back to the desired hour. Be sure to observe the AM or PM indicator to make sure you have set the hour correctly.
3.) Press the Time/Display button again. The Hour digits stop flashing and the Minute digits begin to flash.
4.) While the Minute digits are flashing
press the () or () buttons to move the display forward or back to the desired minute.
14
iP550_041907.p65 | 14 |
19/4/2007, 17:56