General Operation, Power On/Off Mode | Dual XML8110 specification

XML8110 OPERATION

Power On/Off

Mode

Steering Wheel Interface Input

Volume

Mute

Reset

Display

Set the Clock

12/24-Hour Clock

Expansion Slot

General Operation

Press the red power button or any other button to turn the unit on. Press and hold the red power button to turn the unit off.

Press MODE to select between AM/FM, Auxiliary input, Bluetooth and iPod modes. Modes of operation are indicated in the display.

Note: iPod mode will not appear unless an iPod has been connected using the in-dash iPod dock located behind the front panel. Bluetooth mode will not appear unless the BTM60 Bluetooth module is connected.

The steering wheel interface input located on the back of the head unit allows connection to the PAC (Pacific Accessory Corporation) SWI-PSinterface module (sold separately). Visit www.pac-audio.com for details.

To configure steering wheel controls, follow the instructions provided with the PAC SWI-PSinterface module. After installing the interface module, insert the module's 3.5mm jack into the port on the back of the head unit.

Adjust volume using volume knob (00-46).

Press to silence the audio. “MUTE” will flash in the display. Press again to cancel.

Press to RESET the unit upon initial installation or if abnormal operation occurs. The reset button is located to the right of the iPod dock.

Press DISP to toggle between items such as clock and radio frequency.

With the unit on, press and hold DISP until the clock begins to flash, then release. Press TUNE nnto adjust the hours and TUNE llto adjust the minutes. Press DISP momentarily to save the selected time.

The clock will display 12-hour AM/PM time in USA frequency spacing mode (PM 10:00). In European frequency spacing mode, the clock will display 24-hour time (22:00).

The expansion slot provides an easy way to upgrade the XML8110 with new features. Check www.dualav.com for more details.