Parts and Functions
Clock Set
When unit is started for the first time and after replacing batteries in remote controller, clock should be adjusted as follows:
1.Press CLOCK button,"AM" or "PM" flashes.
2.Press
or
to set correct time. Each press will increase or decrease
1min. If the button is kept depressed, time will change quickly.
3.After time setting is confirmed, press SET, "AM" or "PM" stop flashing, while clock starts working.
FRESH
POWER/SOFT
Remote controller's operation
When in use, put the signal transmission head directly to the receiver hole on the indoor unit.
The distance between the signal transmission head and the receiver hole should be within 7m without any obstacle as well.
Don't throw or knock the remoter controller.
When
Loading of the battery
Load the batteries as illustrated right 2
Remove the battery cover:
Slightly press" 
"area and push down the cover as illustrated.
Load the battery:
Be sure that the loading is in line with the "+" /
Put on the cover again.
Confirmation indicator:
After pressing power ON/OFF, if no display, reload the batteries.
Note:
Full display or unclear display during operation indicates the batteries have been used up. Please change batteries.
Used two new
If the remote controller can't run normally during operation, please remove the batteries and reload several minutes later.
Hint:
Remove the batteries in case unit won't be in usage for a long period. If there are any display after
15