Haier HWF05XC3 manual Locating Unit Window

2	INNER
	SILL

1.This unit is designed for installation in standard double hung windows with actual opening widths of 22 to 36 . The upper and lower sash must open sufficiently to allow a clear vertical opening of 14 from the bottom of the sash to the window stool.

2.If storm window presents interference, fasten a 2 wide wood strip(not included) (OUTER SILL) to the inner window sill across the full width of the sill. The wood strip should be thick enough to raise the height of the window sill so that the unit can be installed without interference by the storm window frame (STORM WINDOW FRAME) or wood strip (OUTDOORS) to help condensation to drain properly to the outside.

3.Install a second wood strip (approximately 6 long by 3/2 wide and same thickness as first strip) in the center of the outer sill flush against the back off the inner sill. This will raise basepan angle .

4.If the distance between STORM WINDOW FRAME and WOOD STRIP MOUNTED ON TOP OF INNER SILL is more than 1 , two of wood strip are not necessary.

I		O
N		U
D		T
O		D
O		O
R	OUTER	O
S		R
	SILL	S

WOOD STRIP	1 MAX.
MOUNTED ON
TOP OF INNER SILL	3/4 CLEARANCE
	STORM
	WINDOW FRAME

INNER		WOOD STRIP		O
SILL
	I	FOR BASEPAN		U
	N	ANGLE	OUTER	T
	D			D
	O		SILL	O
	O			O
	R			R
	S			S

LOCATING UNIT IN

WINDOW

Open the window and mark center line on the center of the inner sill.

ATTACH BASEPAN

ANGLE

Install the basepan angle behind the inner window sill, with the short side of basepan angle as shown. Use the 2 short screws13/32" provided.

The basepan angle helps to hold unit securely in place. Be sure to place basepan angle edge flush against back of inner sill.

INNER SILL

SHORT SCREW13/32"

INNER SILL

CENTER LINE

OUTER SILL CENTER LINE

INSIDE

8

INDOOR SIDE

SHORT SIDE 8

OUTSIDE

BASEPAN ANGLE

12